Cogan
Wire Mesh Partition Options

Doors

Material Specifications

Panels

Frames are made of angle 1 1/4" x 1 1/4" heavy duty structural 10 ga. steel, shaped for extra strength. Corners are notched and seam-welded. Wire mesh is 2" x 2" x 10 ga. (.134) clean bright wire, resistance welded at every joint and welded to the frame at every 6". 8' panels are reinforced with two 1/2" round bars, dividing the panel in three equal sections.

Posts

Standard posts are 8' high, 2" x 2" seam-welded square steel tubing. Standard post spacing is either 8', or 10' center.

Doors (swing)

Swing doors are made of the same material and method as the panels, plus a 1 1/2" x 1/2" flat steel bar welded across the center and two 1/2" round diagonal stay bars. Doors are equipped with a set of padlocking hasps, two door stoppers and 1 1/2" pair of steel pin hinges unless otherwise specified.

Doors (sliding)

Sliding doors are also made of the same material and methods as the panel and reinforced with 1 1/2" square tubing bolted to the rear leading edges. Doors are equipped with equivalent #68 stanley track, two #64 hangers, door guide, receiver and a set of hasps for padlocking.

Roofs

Roof panels are made of the same material and method as regular panels and are designed for security purposes only. Roof panels are not live load-bearing capable unless designed and ordered for a specific load.

Finish

Finishes are standard Cogan grey.

Hardware

All necessary assembly fasteners are provided except floor and wall anchors.